光码分多址系统中光学相关接收机判决阈值的分析

介绍了光码分多址系统中常用地址码（一维扩时码、二维码和三维码）的特点，并对它们各自的互相关均值和方差进行了理论分析。基于非相干光码分多址系统中光学相关接收机的基本原理，结合不同的用户地址码，对系统误码率性能进行了分析，得到了接收机最佳判决阈值与地址码基本特性参数和系统同时用户数间的关系。最后，给出了数值仿真结果。结果表明，对于采用特定地址码的光码分多址系统，只有选择合适的接收机判决阈值，系统的误码率性能才能达到最佳。研究结果对光码分多址系统中接收机判决阈值的选取具有一定的参考作用。     

提高微晶硅薄膜太阳电池效率的研究

采用甚高频等离子体增强化学气相沉积技术制备了系列微晶硅薄膜太阳电池，指出了气体总流量和背反射电极的类型对电池性能参数的影响.电池的I-V测试结果表明：随反应气体总流量的增加，对应电池的短路电流密度、开路电压和填充因子都有很大程度的提高，结果使得电池的光电转换效率得以提高.另外，ZnO/Ag/Al背反射电极能明显提高电池的短路电流密度，进而也提高了电池的光电转换效率.对气体总流量和背反射电极类型影响电池效率的原因进行了分析. 关键词： 微晶硅薄膜太阳电池 气体流量 ZnO/Ag/Al背反射电极     

Development of a Simulation Model for Solid Objects Suspended in a Fluctuating Fluid

We introduce a new scheme for the future application of Real-coded Lattice Gas (RLG) to the numerical simulation of suspended solid objects in a fluctuating fluid environment. The reproduction of Brownian motion for a single solid object is verified through the Gaussian distribution of its displacements. The effectiveness of the solid–solid interaction model is also confirmed in an N-body simulation.     

量子点器件的三端电测量研究

利用三端电测量方法，研究了调制掺杂二维电子气结构的量子点器件输运特性.报道了可分别测量二维电子气电阻和量子点隧穿电阻的实验方法.实验结果表明：量子点的横向耦合控制了量子点器件在小偏压下的电输运特性. 关键词： 自组装量子点 二维电子气 量子隧穿 肖特基接触     

曲轴箱窜气量检测仪的研制

介绍了车用压差式气体流量传感器的结构设计和电测电路，指出了传感器的使用范围，由实验测出了特性曲线．该仪器可检测车用发动机曲轴箱窜气量，适用于发动机不解体故障诊断．     

Measurement of elastin hydrolysis by reverse-phase HPLC with on-line post-colum derivatization

Summary Excessive breakdown of elastin, a structural protein, may be related to aortic disease and emphysema. Since L-valyl-L-proline occurs in high concentrations in elastin, a rapid and sensitive method using HPLC with post-column on-line derivatization was used to measure the dipeptide from swine aortic tissue, and the amount of elastin present was determined. Elastin was extracted by alkaline hydrolysis. After neutralization and filtration, the sample was injected onto a ODS-2 gel column, and the dipeptide was eluted by a linear gradient of 0 to 10% of 1-propanol in 50 mM heptafluorobutyrate, pH 3, at a flow rate of 1 ml/min. The eluent was reacted with fluorescamine at pH 8.6, and fluorescence was detected at an excitation wavelength of 395 nm and a 455 nm cutoff emission filter.Presented at the 17th International Symposium on Chromatography, September 25–30, 1988, Vienna, Austria.     

Liquid–gas critical phenomena under confinement: small-angle neutron scattering studies of CO2 in aerogel

Small angle neutron scattering (SANS) is a well-established technique for investigating the behavior of confined binary liquid solutions, as it can probe the correlation length and susceptibility in pores on length scales 1 – 100 nm. We applied SANS to explore the influence of confinement on critical behavior of an individual fluid carbon dioxide (CO₂) in a highly porous aerogel. The results demonstrate that quenched disorder induced by aerogel significantly depresses density fluctuations. Despite the negligible volume occupied by aerogel (< 4%), the macroscopic phase separation of confined CO₂ into coexisting liquid and gaseous phases is suppressed and below the critical temperature of the bulk fluid frozen methastable microdomains are formed. Experimental data show that critical adsorption is as important as the effect of confinement in defining the behavior of confined fluids.     

Characterization of a 4-miktoarm star copolymer of the (PS-b-PI)3 PS type by temperature gradient interaction chromatography

Temperature gradient interaction chromatography (TGIC) was applied for the separation of a complex miktoarm star copolymer which has one polystyrene (PS) arm and three polystyrene-b-polyisoprene (PS-b-PI) diblock copolymer arms. Such miktoarm star polymers are much more difficult to characterize than branched homopolymers since the byproduct, typically polymers with missing arm(s) or coupled products, have not only different molecular weights but also different compositions. TGIC was able to fully separate the byproducts, and the composition of the molecular species corresponding to the different separated elution peaks was determined by two methods, fractionation/NMR and multiple detection (UV and RI). A reasonable agreement between the results of the two methods was obtained. By using the composition found, the corresponding molecular weights were determined by multi-angle light scattering detection. Based on the composition and the molecular weight we were able to identify the structure of the different molecular species.     

毛细管气相色谱法测定中药中有机氯农药残留量

建立了江西省两种中药中有机氯农药残留量的气相色谱分析方法。样品以丙酮提取,在NaCl存在下,以正已烷进行液—液分配,提取液用H2SO4净化,采用DB—1701毛细管柱,GC—ECD检测有机氯农药残留量。最低检测限为1.0×10-3-5.0×10-3mg/kg,添加回收率为85.7%-115.2%,应用于实际样品中有机氯农药残留量的检测,获得了较为满意结果。     

Improvement of gas meter performance using polymer materials

The measuring elements of both dry‐ and wet‐type gas meters are composed of a diaphragm and rotary drum. In this article an explanation on the principle of measuring and the structure of the gas meter for each of these two types was discussed. Such applications were made as follows: synthetic rubber was used for the measuring diaphragm, engineering plastic was employed instead of metal for the measuring drum, and poly(butylene terephthalate) (PBT) was used for the casing, respectively. As a result, an improvement in the gas resistance performance and productivity, which led to a lighter weight, more compactness and a lower cost of productions was achieved. Also the influence of the solubility of the measured gas to the plastic on the measured valve was discussed. Copyright © 2003 John Wiley & Sons, Ltd.